Siemens Building Technologies, Inc. I
Landis Division
H
HH
How
ow ow
ow T
TT
To
o o
o Us
UsUs
Use
ee
e
Th
ThTh
Thi
ii
is
s s
s M
MM
Manua
anuaanua
anual
ll
l
This manual is written for the owner and user of the System 600 APOGEE Open Processor
with Trane driver, referred to as
Open Processor
for the remainder of this manual. It is
designed to help you become familiar with the Open Processor and its applications. The
manual contains the following information:
This section covers manual organization, manual conventions and symbols used in the
manual, how to access help, related publications, and any other information that will help you
use this manual.
M
MM
Manua
anuaanua
anual
ll
l
O
OO
Org
rgrg
rga
aa
an
nn
nz
zz
za
aa
at
tt
ti
ii
io
oo
on
nn
n
x
Chapter 1,
Introduction
, describes each chapter in this manual and presents an
overview of the Open Processor operation.
x
Chapter 2,
Hardware
, describes and explains the function of the Open Processor and
related hardware.
x
Chapter 3,
Software
, describes the software contained in the Open Processor.
x
Chapter 4,
Point Database
, defines the Open Processor’s point database.
x
Chapter 5,
Applications
, describes the applications available with the Open
Processor. Point maps, complete with slopes and intercepts, are included for each
supported Trane equipment controller.
x
Chapter 6,
Troubleshooting
, describes basic corrective measures to take if you
encounter a problem when using the Open Processor. This chapter is not intended
to serve as a full diagnostic guide. Rather, it is designed to address basic
troubleshooting issues. If you encounter a problem not covered in this chapter or
require further assistance, consult your local Siemens Building Technologies
representative.
x
A
Glossary
describes the terms and acronyms used in this manual.
x
An
Index
is provided to help you locate information presented in this manual.
To Next Page
Loading...
Need help?
General
