Siemens OpenStage 80 SIP Operating Manual

Step by Step
Enhanced phone functions
92
Held call wait status
After placing a call on hold, you can replace the handset
and then decide if the call should be retrieved or discon-
nected.
Prerequisite: You placed a call on hold and replaced the
handset.
In the pop-up menu:
Select and confirm the option shown to resume the call
in speakerphone mode.
or
Select and confirm the option shown to disconnect the
call.
Activating/deactivating the hold reminder tone
z
You can also configure this setting via the Web interface
Æ page 230.
v Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown in the context
menu.
Select and confirm the option shown.
The LED display Æ page 26 or status display on
the "Overview" tab Æ page 38 indicates that the
call is on hold to other multi-line telephones
where this line is also configured. These phones
can then pick up the call.
Retrieve held call
Disconnect
User
Configuration
Connected calls
Allow hold rem.
Yes
Save & exit

Siemens OpenStage 80 SIP Specifications

General

Brand	Siemens
Model	OpenStage 80 SIP
Category	IP Phone
Language	English