36 Optiset E QRG
Station / Individual Speed Dialing
This feature lets you assign frequently called external numbers
to a code (*0 through *9). You can then dial this digit code
instead of the entire telephone number. The Hicom 150 E CS
allows a dialing sequence of up to 25 characters to be assigned
to each digit code.
Note:
For the feature described here, this procedure uses a
Speed Dial key that is programmed by your system
administrator.
To set up a station speed dial code
1. Dial * 92.
2. Dial a speed dial index code (*0 through *9) and select
Change?
.
3. Enter the dialing sequence that the code will represent. You
may be required to include an access code for an external
line.
4. Select
Save?
or to program a different speed dial code, scroll
to
Next?
and select it.
5. When you are finished, scroll to and select
Exit?.
To dial using a station speed dial code
To use the station speed dial feature, use the OptiGuide Display
to follow these steps:
1. When your telephone is idle, press the Speed Dial key
or dial * 7.
2. Dial the station speed dialing index code.
Refer to “Feature Access Codes” on page 39 for information on
accessing features through special access codes.
To Next Page
Loading...
