92 | Part 3
■ M52 AUTO DOOR OPEN
Open splash guard door automatically in the machine where auto splash guard door is
installed.
■ M53 AUTO DOOR CLOSE
Close splash guard door automatically in the machine where auto splash guard door is
installed.
■ M54 PARTS COUNT
Function
Count the quantity of workpiece that has finished machining and display the quantity
in CRT.
■ M66 DUAL CHUCKING LOW CLAMP
Function
Change chucking pressure into low pressure. (After commanding, chucking LED is
blink in clamp state)
Condition of Command
After commanding M66, once unclamp chuck and then clamp. By this way, chucking
pressure is normally down.
Main chuck maintains its low pressure state.
■ M67 DUAL CHUCKING HIGH CLAMP
Function
Change chucking pressure into high pressure. (After commanding, chucking LED is
ON in clamp state)
Condition of Command
After commanding M67, once unclamp chuck and then clamp. By this way, chucking
pressure is normally up.
Main chuck maintains its high pressure state.
To Next Page
Loading...
