Siemens PUMA V8300/M - Service Planner

MAINTENANCE | 139
4. Service Planner
With the “Service Planner”, maintenance tasks have been set up that have to be performed
at certain interval (e.g. change coolant).
A list is displayed of all the maintenance tasks that have been set up together with the time
remaining until the end of the specified maintenance interval.
The current status can be seen in the status display.
Messages and alarms indicate when a task has to be performed.
Acknowledging a maintenance task
Acknowledge the message when a maintenance task has been completed.
Display
Meaning
Pos
Position of the maintenance task in the PLC interface.
Maintenance task
Name of the maintenance task
Interval [h]
Maximum time until next servicing in hours
Remaining time [h]
Time until the interval expires in hours
Status
Display of the current status of a maintenance task
The maintenance task has been started
The maintenance task is completed
The maintenance task is deactivated