Siemens PUMA V8300/M - Chip Conveyor(Option); Chip Conveyor Operation

OPERATION | 79
16. CHIP CONVEYOR(OPTION)
This is the device to extract the chip that is generated in machining to the outside of
machine. Basically in the lateral side of electric control cabinet, the connector is prepared to
attach chip conveyor.
Classification
Spec. of connector in box
Wiring No.
Standard/Option
Chip conveyor
MS3102A 22-14S
WM0610
Option
In case of attaching chip conveyor by customer oneself, attach chip conveyor after consulting
with DHIM.
16.1 Chip conveyor operation
The next operating explanation is only for attaching chip conveyor of DHIM. In case of
another chip conveyor, operation method may be different with explanation listed below.
(1) Manual operation
Manual operation panel of chip conveyor is attached to the chip conveyor.
Forward operation switch : Chip conveyor will be rotated in the forward direction.
Reverse operation switch : Chip conveyor will be rotated in the reverse direction.
Stop switch : Chip conveyor will be stopped.
Operation is available regardless of the operation mode of machine, but the machine
must be in the status listed below.
- Machine ready status
- The status that the front door is closed.
(2) Automatic operation
Chip conveyor can be operated using M-code listed below.
M24 ; Conveyor forward rotation
M25 ; Conveyor stop
And operation method may be different according to the setting of machine data.
MD
14512[11].1
Set to "0"
After commanding M24, additional command such as M25 is
required in order to stop conveyor
Set to "1"
After command M24, additional command isn’t required in
order to stop conveyor. The conveyor will stop automatically
after the time set in machine data parameter elapsed.