MAIN OPERATION PANEL | 5
When pressing the Jog Mode Switch, The LED is ON and the
machine will be changed to jog mode.
Jog mode can operate the Jog feed of each axis.
And select the target axis on the panel, and press the direction
button to move the corresponding axis, each axis will be moved
toward the selected direction and the speed which is set in
feedrate switch
When pressing the Handle mode switch, The LED is ON and the
handle axis must be selected. If rotating the hand wheel in Handle
mode of selected axis, axis feed can be activated at the selected
ratio of the Incremental Feed.
Note 1) B axis, C axis and Y axis are additional axis according to
machine type.
To Next Page
Loading...
