MAIN OPERATION PANEL | 11
(9) Spindle control Switch in manual mode
1) Spindle rotating direction selection & Jog switch
These switches are used to rotate the selected spindle in
the CW or CCW direction. Be sure to determine the rotation
direction after selecting the spindle selection switch in
2.2.8.
If looking to spindle in back view, clockwise rotation
direction is forward. The counter-clockwise rotation
direction is reverse.
In manual mode, press the spindle rotation stop switch for
stopping the rotating spindle.
Note 1) Note) It is impossible to rotate spindle by manual
until S-code is commanded in automatic mode
after turning ON the CNC power first. Therefore, in
order to rotate the spindle by manual after CNC
power ON first, command certain Sxxx of S-code
in MDA mode.
When manual jog operation is selected, the spindle will be
rotated as long as pressing the spindle jog button.
Spindle CW LED ON : indicates to select the CW. rotation of the selected spindle.
Spindle CCW LED ON : indicates to select the CCW rotation of the selected spindle.
Spindle Jog LED ON : indicates to select the spindle Jog operation.
When door is open with setting mode key ON, the maximum spindle speed is 50
rpm. And spindle will be rotated as long as the spindle CW, CCW or JOG button is
pressed.
2) Spindle rotation start & stop switch
These buttons are different from the above spindle CW,CCW
and stop button. The above buttons are available in manual
mode only.
These buttons on the left are used to activate /deactivate the
spindle. During spindle is running in AUTO mode, the spindle
can be stop by spindle stop button, and run again with spindle
start button. And these buttons have higher priority than the
above buttons.
To Next Page
Loading...
