28 | Part 2
(2) Jog feeding speed
Feeding speed is decided by the status of feed override
switch as shown in left side figure. When this switch is in
100%, the speed is set in NC parameter. And within the
range of 0~120%,
(3) Jog traverse limit
1) In case that front door of machine is open, axes are impossible to traverse rapidly
using jog switch.
2) In case that Q-setter is down, Jog axis traverse is possible with front door open.
However, traverse speed is limited. But in some machine, the axes are adjusted not
to traverse.
3) According to the condition of machining such as tapping, C-axis can be clamped. In
case that C-axis is clamped, C-axis traverse is limited.
To Next Page
Loading...
