– Fan speed: The manual fan is below or equal to the auto fan speed value
– Operating mode: The manual mode is lower or equal to the scheduler
mode
● Red leaf: The settings exceed the preset energy-efficiency range
P110 configures the green leaf function:
● 0 = Disabled (OFF)
● 1 = Green and red dimmed down
● 2 = Green dimmed down / red fixed
● 3 = Green and red fixed
Exceed the preset energy-efficient
range
Touch to reset user setting
Time synchronization via bus
Time of day and date information are received from a Synco controller with time
master function (RMB, RMB, OWZ, etc) or any other KNX device e.g. GPS clock
if the corresponding communication object is bound.
The scheduler function must be enabled before setting the time of day:
● Press once and then turn the rotary knob or press continuously to
select programming mode TIME.
● Press once and then turn the rotary knob to select the time format.
● If 12H is selected, press once and then turn the rotary knob to select AM or
PM.
● Press once and enter the hour setting.
● The hour value flashes and can be changed by turning the rotary knob.
● Press once to confirm the adjusted value and enter the minutes setting.
Repeat the steps as for the hour.
When time format is 24 h, AMPM is not displayed.
To Next Page
Loading...
Need help?
General
