Set DATE
The scheduler function must be enabled before setting the date:
● Press once and then turn the rotary knob or press continuously to
select programming mode DATE.
● Press once to enter the date setting.
● Turn the rotary knob to select month / weekday / year, then press once.
● For example, enter the year setting. The Year value flashes and can be
changed by turning the rotary knob.
● Press once to confirm the adjusted value, or (Esc) to cancel the change.
Repeat steps for month and weekday settings.
Set AWAY (Holiday mode)
The holiday start time (date and month) can be set after entering holiday mode.
The scheduler function must be enabled before setting the holiday period:
● Press once and then turn the rotary knob or press continuously to
select programming mode AWAY. Holiday mode is displayed once the start
time reaches.
● Press once to enter scheduler mode .
● Turn the rotary knob to adjust the number of days (holidays), then press
once.
● Set the start time (AWAY): Set the month (MON) and then press ⇒ Set the
day (DAY)
● Press once to confirm the adjusted value; the idle page for Holiday mode is
displayed.
● Holiday mode only can be set via local HMI.
● Only the local HMI or window contact/presence detector can stop holiday mode.
Intervention from the bus cannot change the mode. Holiday mode remains
active until the next intervention from a local HMI or window contact/presence
detector is received.
● The set holiday mode is deleted once the setting holiday period ends and users
need set a new one as desired next year.
To Next Page
Loading...
Need help?
General
