From OUT to ON (first 5 seconds)
From ON to OFF (after 5 seconds)
Notes
Mounting
When mounting the transmitter, attach the baseplate first. You need to mount the transmitter
on a flat wall. (For details, refer to the separate mounting instructions A6V10974421.)
The transmitter comes with a fold-out stand and may be used as a “mobile” device.
Mounting the receiver does not require a baseplate. Connect the electrical connections first
and then fit and secure the receiver in compliance with local regulations. (For details, refer to
the separate mounting instructions A6V10974421.)
EMI filter (e.g., KEILS EMI CW4L2-3-R) can be used to reduce EMI disturbance. (For details,
see Connection diagram [▶ 14].)
Electric shock on directly touches of EMI filter
● Disconnect from power supply before connecting EMI filter.
● Make sure EMI filter is out of reach after installation.
If the reference room contains thermostatic radiator valves, set them to their fully open
position.
For commissioning, refer to the operating instructions A6V101035988.
Communication of the RDH100RF/SET (transmitter and receiver) is paired ex factory.
● The devices are suitable for wall mounting.
● Recommended height: 1.5 m above the floor.
To Next Page
Loading...
Need help?
General
