Chapter 6
Certification
RUGGEDCOM RX1501
Installation Guide
48 FCC Compliance
Agency Standards Comments
Cellular LM Models RX1500PN-W11-XX
RX1500PN-W12-XX RX1500PN-W32-XX
FCC ID for W11 and W12: N7NMC8705
FCC ID for W32: N7NMC8705/N7N-MC5728
IC ID for W11 and W12: 2417C-MC8705
IC ID for W32: 2417C-
MC8705/2417C-MC5728
Section 6.2
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference on his own expense.
Section 6.3
Industry Canada Compliance
CAN ICES-3 (A) / NMB-3 (A)
Section 6.4
EMI and Environmental Type Tests
The RX1501 has passed the following EMI and environmental tests.
IEC 61850-3 EMI Type Tests
Test Description Test Levels
Severity
Levels
Enclosure Contact +/- 8 kVIEC 61000-4-2 ESD
Enclosure Air +/- 15 kV
4
IEC 61000-4-3 Radiated RFI Enclosure Ports 20 V/m
Signal ports +/- 4 kV @ 2.5 kHz
Note
a
DC Power Ports
AC Power Ports
IEC 61000-4-4 Burst (Fast Transient)
Earth ground ports
+/- 4 kV 4
To Next Page
Loading...
Need help?
General