Siemens RUGGEDCOM RX1510 - Chapter 3 Modules

RUGGEDCOM RX1510
Installation Guide
Chapter 3
Modules
17
Modules
The RUGGEDCOM RX1510 features slots for up to two field-replaceable line modules, which can be used to
expand and customize the capabilities of the device to suit specific applications. A variety of modules are available,
each featuring a specific type of communication port: copper Ethernet, fiber optic Ethernet, SFP, WAN, cellular
modem and DDS. The RUGGEDCOM APE (Application Processing Engine) line module, a utility-grade computing
platform for running third-party applications directly from within the RUGGEDCOM RX1510, is also available.
Modules can be installed in any one of the available slots in the device chassis.
Use the RUGGEDCOM ROX II software to determine which ports are equipped on the device. For more information,
refer to the RUGGEDCOM ROX II User Guide for the device.
NOTE
Only one T1/E1 WAN module and up to two DDS modules are supported.
4321
Figure13:Available Chassis Slots
1.Slot 1 2.Slot 2 3.Slot 3 4.Slot 4
CONTENTS
• Section3.1, “Available Modules”
• Section3.2, “Installing/Removing Line Modules”
• Section3.3, “Installing/Removing Power Modules”