Siemens RUGGEDCOM RX1510 - Installing;Removing Power Modules

Chapter 3
Modules
RUGGEDCOM RX1510
Installation Guide
28 Installing/Removing Power Modules
1
2
3
Figure15:Installing a Module
1.Module 2.Chassis 3.Screw
5. Tighten the screws to secure the module.
6. [Optional] If necessary, install the device in the rack.
7. Connect power to the device.
Section3.3
Installing/Removing Power Modules
The RUGGEDCOM RX1510 supports dual redundant power supply modules.
1
2
Figure16: Power Modules
1.Slot PS1 2.Slot PS2