Siemens S7-400 - Page 5

Preface
CP 443-1 Advanced
Equipment Manual, 03/2023, C79000-G8976-C256-07
5
Notes on this document
Product names/abbreviations
• CP
In this document, the term "CP" is also used instead of the full product name CP 443-1
Advanced.
• EX11 / EX41 / GX20 / GX30
The abbreviations used in this manual for the modules (for example "GX20" or "EX41")
correspond to the last four characters of the mid-section of the article number of the
respective module.
• STEP 7
The name STEP 7 is used for the configuration tool instead of the names STEP 7 V5 and
STEP 7 Professional, if the respective function is supported by both configuration tools.
Cross-references
In this manual, there are often cross-references to other sections. To return to the original
page after jumping to a cross-reference, some PDF readers support the command <Alt>+<Left
arrow>.
Search
To show all places where a term was found in a list, some PDF readers support the command
<Ctrl>+<Shift>+<F>.
Structure of the documentation
The documentation for this device consists of the following parts:
• Manual Part A: Configuration manual "Configuring and Commissioning S7 CPs for
Industrial Ethernet", see /2/ (Page 103).
Relevant for configuration with STEP 7 V5
• Manual Part B: Manual "CP 443-1 Advanced" (this manual)
• SIMATIC NET Industrial Ethernet Security - Basics and Application, configuration manual,
see /11/ (Page 105)
Relevant for configuration with STEP 7 V5
• Program blocks for SIMATIC NET S7 CPs - programming manual, see /14/ (Page 106)
Contains the detailed description of the program blocks for the following services:
– Open communications services
– Access coordination with FETCH/WRITE
– Connection and system diagnostics
– FTP services
– Programmed connections and IP configuration
– PROFINET
Relevant for configuration with STEP 7 V5