Assembling the M7-400
8-23
S7-400 and M7-400 Programmable Controllers Hardware and Installation
A5E00069481-04
3. Press the connecting clip on its two 90° ends downward until it engages.
Figure 8-11 shows a connecting clip in its final position.
4. Carry out steps 1 to 3 similarly on the bottom of the modules to be secured.
Bent clip end
Clip end bent
90°
Figure 8-10 Connecting Clip
Fifth grid hole
Figure 8-11 Securing the Modules with Connecting Clips (Schematic Diagram)
To Next Page
Loading...
