cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan outdoor
Result
The outdoor mode is enabled.
Further notes
You display the setting with the show wlan basic <wlan 0/X> command.
You disable the function with the no wlan outdoor command (default setting).
See also
no wlan outdoor (Page 260)
7.1.5.58 no wlan outdoor
Description
With this command, you disable the outdoor mode or enable the indoor mode. This setting is
activated as default.
In indoor mode, all the country-dependent permitted channels and transmit power settings are
available for operation in a building.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan outdoor
Result
The indoor mode is enabled or the outdoor mode is disabled.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
260 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
