cli (config-wlan-context-x)#
Syntax
Call up the command with the following parameters:
wlan security dot1x password <string>
The parameter has the following meaning:
Parameters Description Range of values / note
string New password Enter the password for the user name. You specify the
user name with the wlan security dot1x
username command
Result
The password is specified.
Further notes
You display the settings with the show wlan security command.
11.3.4.9 wlan security encryption (client)
Description
With this command, you enable encryption with a fixed (unchanging) WEP key. You can only
enable or disable encryption if you have selected "Open System" for authentication. All other
security methods include both authentication and encryption. If you use "Open system" with
"Encryption" or "Shared Key", you always need to specify the WEP key used for the encryption.
Note
This command is only available in the client mode.
Requirement
● The type of authentication is "open system".
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call the command without parameter assignment:
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
522 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
