Siemens SCALANCE W774-1 RJ-45 Configuration Guides

Further notes
You disable the setting with the no firmeware-in-configpack command.
4.2.5.13 no firmeware-in-configpack
Description
With this command you take firmware file out of the ConfigPack file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call the command without parameter assignment:
no firmeware-in-configpack
Result
The function is disabled.
Further notes
You enable the function with the firmeware-in-configpack command.
4.3 Reset and Defaults
This section describes commands for restarting the device and for restoring the original
configuration.
4.3.1 restart
Description
With this command, you restart the device.
Configuration
4.3 Reset and Defaults
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 99

Siemens SCALANCE W774-1 RJ-45 Specifications

General

Device Type	Wireless Access Point
Model	SCALANCE W774-1 RJ-45
Wireless Standard	IEEE 802.11a/b/g/n
Frequency Band	2.4 GHz / 5 GHz
Maximum Data Rate	300 Mbps
Operating Temperature	-20 °C to +60 °C
Protection Class	IP30
Ethernet Interface	1 x RJ45
Ports	1 x RJ45
Antenna	Integrated antennas
Power Supply	24 V DC
Mounting Type	DIN rail or wall mounting