Siemens SCALANCE W774-1 RJ-45 - IP Access Control List; The Show Commands

deny {any|host<src-mac-address>}{any|host<dest-mac-address>}
The parameters have the following meaning:
Parameter Description Range of values / note
any Keyword for "all" -
host Keyword for the MAC address of an in‐
coming connection that is locked
-
src-mac-address MAC address of the locked incoming
connection
Specify a valid MAC address.
any Keyword for "all" -
host Keyword for the MAC address of an out‐
going connection that is locked
-
dest-mac-address MAC address of the locked outgoing
connection
Specify a valid MAC address.
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Note
MAC address input
Use "any", if the rule is to apply to all src and/or dest MAC addresses. This corresponds to the
MAC address "00:00:00:00:00:00".
Result
The MAC access control list is configured.
Further notes
You exit the MAC ACL configuration mode with the exit command.
You delete the MAC access control list with the no mac access-list extended command.
You display the configuration of the access control list with the show access-lists
command.
11.5 IP access control list
This section describes commands for working with IP access control lists.
11.5.1 The "show" commands
This section describes commands with which you display various settings.
Security and authentication
11.5 IP access control list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 553