Siemens SCALANCE W774-1 RJ-45 Configuration Guides

7.1.6.4 no vap broadcast ssid (access point)
Description
With this command, you disable the "Broadcast SSID" function. The SSID is no longer sent in
the frame of the access point. This means that the SSID is not visible for other SCALANCE
W700 devices. Only stations that know the SSID of the access point and that are configured
with it can connect to the access point. The "Any SSID" option must be disabled on these
clients.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameter assignment:
no vap broadcast ssid
Result
The function is disabled.
Further notes
You display the setting with the show wlan vap <vap X 0/Y>command.
You enable the function with the vap broadcast ssid command (default setting).
See also
vap broadcast ssid (access point) (Page 266)
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 267

Siemens SCALANCE W774-1 RJ-45 Specifications

General

Device Type	Wireless Access Point
Model	SCALANCE W774-1 RJ-45
Wireless Standard	IEEE 802.11a/b/g/n
Frequency Band	2.4 GHz / 5 GHz
Maximum Data Rate	300 Mbps
Operating Temperature	-20 °C to +60 °C
Protection Class	IP30
Ethernet Interface	1 x RJ45
Ports	1 x RJ45
Antenna	Integrated antennas
Power Supply	24 V DC
Mounting Type	DIN rail or wall mounting