The parameter has the following meaning:
Parameter Description Range of values / note
string WPA(2) key 8....63ASCII or exactly 64 hex
Result
A WPA(2) key is specified.
Further notes
You display the settings with the show wlan security command.
See also
wlan security authentication (client) (Page 514)
11.3.5 Commands in the VAP Interface configuration mode
This section describes commands that you can call up in the VAP Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the interface vapX 0/Y command to change to
this mode.
● If you exit the VAP Interface Configuration mode with the exit command, you return to
the Global Configuration mode.
● If you exit the VAP Interface Configuration mode with the end command, you return to the
Privileged EXEC mode.
11.3.5.1 vap security authentication (access point)
Description
With this command, you specify the type of authentication.
Note
This command is available only in access point mode.
Note
iPCF, iPCF-HT or iPCF-MC mode activated
If iPCF, iPCF-HT or iPCF-MC mode is enabled, only "Open System" with the encryption
method AES is supported in the security settings with Security Context 1.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 525
To Next Page
Loading...
