Siemens SCALANCE W774-1 RJ-45 Configuration Guides

cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree {cost <0-200000000>|disable|
link-type{point-to-point|shared}|portfast|
port-priority<0-240>}
The parameters have the following meaning:
Parameter Description Range of values / note
cost Keyword
Describes the costs of the port for cal‐
culating the lowest cost path.
0 ... 200000000
Default:
if dynamic calculation of the path
costs is not enabled:
● 200000 for physical interfaces
● 199999 for port channels
disable disables the interface for spanning tree -
Default:
The spanning tree function is ena‐
bled on the interface
link-type Connection status of the following net‐
work segment
● point-to-point
● shared
Default:
● point-to-point
The connection is configured
as full-duplex
● shared
in all other cases
portfast Enables the PortFast function -
Default: disabled
port-priority Priority of the interface 0 ... 240 in steps of 16
Default: 128
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected property is configured.
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 325

Siemens SCALANCE W774-1 RJ-45 Specifications

General

Device Type	Wireless Access Point
Model	SCALANCE W774-1 RJ-45
Wireless Standard	IEEE 802.11a/b/g/n
Frequency Band	2.4 GHz / 5 GHz
Maximum Data Rate	300 Mbps
Operating Temperature	-20 °C to +60 °C
Protection Class	IP30
Ethernet Interface	1 x RJ45
Ports	1 x RJ45
Antenna	Integrated antennas
Power Supply	24 V DC
Mounting Type	DIN rail or wall mounting