Installation and Maintenance
5.3 Installation on a Standard Rail
Figure 5-2 Removing a SCALANCE X-100 and/or X-200 from a 35 mm Standard Rail
5.3 Installation on a Standard Rail
Installation on a SIMATIC S7-300 Standard Rail
1. Place the upper guide at the top of the SCALANCE housing in the S7 standard rail.
2. Screw the Industrial Ethernet switches of the SCALANCE X-100 and X-200 product lines
to the underside of the standard rail.
3. Fit the connectors for the power supply to the terminal block.
4. Fit the connectors for the signaling contact to the terminal block.
5. Insert the two terminal blocks into the sockets on the device.
Industrial Ethernet SCALANCE X-100 and SCALANCE X-200 Product Line
Commissioning Manual, 1,
5-3
To Next Page
Loading...
