Siemens SCALANCE X-300 - Vrrp; VRRP Virtual Routers

Configuration using Web Based Management and Command Line Interface
4.7 The Router menu (SCALANCE X414-3E)
SCALANCE X-300 / X-400
312 Configuration Manual, 10/2014, C79000-G8976-C187-22
Syntax of the Command Line Interface
Table 4- 100 OSPFv2 State Database - CLI\ROUTER\OSPF>
Command
Description
Comment
lnkstate Displays the current links state
table.
-
Note
For more detailed information on LSAs, refer to the section on configuratio
n and diagnostics
over SNMP.
4.7.13
VRRP
Introduction
In the submenus of the "VRRP" menu, you can set the VRRP parameters.
The VRRP introduces redundancy to the IPv4 network. Various IP routers can take over the
routing functionality of another router if the actual router fails. To allow this, several routers in
an IP subnet are grouped together to form one virtual router This virtual router is assigned a
list of IPv4 addresses for which the relevant master takes on the routing functionality.
4.7.14
VRRP Virtual Routers
Introduction
In this dialog, you can monitor the virtual routers of this system.
With the "New Entry" button, you can create new virtual routers.
A maximum of 32 virtual routers can be configured.