Installation
3.2 Mounting on DIN rails
SCALANCE XB-200
Operating Instructions, 09/2015, C79000-G8976-C359-03
21
Figure 3-1 DIN rail mounting
To install the device on a 35 mm DIN rail complying with DIN EN 60715, follow the steps
below:
1. Place the housing guide of the device on the top edge of the DIN rail
①.
2. Press the device down against the DIN rail until the spring catch locks in place
②.
3. Fit the connectors for the power supply, see the section "Power supply (Page 25)".
4. Insert the terminal blocks into the sockets on the device.
To Next Page
Loading...
