Siemens SED2

4/80
Siemens Building Technologies Commissioning Guide CM1G5192en
HVAC Products Contents 26.02.2003
6.1.1 Setting the DIP switches on the I/O module.................................................. 24
6.1.2 DIP switch settings on the control board....................................................... 24
6.1.3 DIP switch settings on the AOP .................................................................... 24
6.2 Checklist prior to startup ............................................................................... 25
6.3 Buttons and their functions on the operator panel (BOP and AOP)............. 26
6.4 Setting parameters with the BOP or AOP ..................................................... 27
6.5 Quick commissioning .................................................................................... 28
7 Application examples ................................................................................. 29
7.1 Application example 1 ................................................................................... 29
7.1.1 Parameter changes....................................................................................... 30
7.2 Application example 2 ................................................................................... 31
7.2.1 Parameter changes....................................................................................... 31
7.3 Application example 3 ................................................................................... 32
7.3.1 Parameter changes....................................................................................... 32
7.4 Application example 4 ................................................................................... 33
7.4.1 Parameter changes....................................................................................... 33
7.5 Application example 5 ................................................................................... 34
7.5.1 Parameter changes....................................................................................... 35
7.6 Application example 6 ................................................................................... 36
7.6.1 Parameter changes....................................................................................... 36
7.7 Application example 7 ................................................................................... 37
7.7.1 Parameter changes....................................................................................... 38
7.8 Application example 8 ................................................................................... 39
7.8.1 Parameter changes....................................................................................... 39
8 Additional functions.................................................................................... 40
8.1 Belt failure detection without sensor ............................................................. 40
8.1.1 Parameter setting.......................................................................................... 40
8.2 Belt failure detection with sensor .................................................................. 41
8.2.1 Parameter setting.......................................................................................... 41
8.3 Hibernation mode.......................................................................................... 42
9 Error messages ........................................................................................... 43
9.1 Error code list ................................................................................................ 43
9.2 Warning code list........................................................................................... 46
10 Parameterization ......................................................................................... 48
10.1 Block diagram with parameter overview........................................................ 48
10.2 System parameter list for levels 1 to 3 .......................................................... 49
10.3 Overview of factory and user parameter settings.......................................... 76
11 Appendix...................................................................................................... 78
11.1 Applicable standards..................................................................................... 78