Flat Panel
Operating Instructions (Compact), 09/2008, A5E02313712-01
7
Unpack and connect the device
2
2.1 General safety notes
WARNING
Emergencies
In the event of a device fault, remove the mains connector immediately. Inform the
customer service personnel responsible. Malfunctions can occur when the operator controls
or power cable are damaged or when liquids or foreign objects penetrate the device.
2.2 Safety information
WARNING
Following the results of a risk analysis, additional protection equipment on the machine or
the system is necessary to avoid endangering persons. With this, especially the
programming, configuration and wiring of the inserted I/O modules have to be executed, in
accordance with the safety performance (SIL, PL or Cat.) identified by the necessary risk
analysis. The intended use of the device has to be ensured.
The proper use of the device has to be verified with a function test on the system. This test
can detect programming, configuration and wiring errors. The test results have to be
documented and, if necessary, entered into the relevant documents that verify safety.
Electrical connection
WARNING
Disconnect the device from the mains before every intervention.
Do not touch power lines or data transmission lines or connect any cables during electrical
storms.
To Next Page
Loading...
