Siemens SIMATIC ET 200S - ET 200 S components

Alarm processing
6
6.1 Overview
Sequence of the alarm processing
Pending error messages are processed and evaluated differently than in a SIMATIC system.
Diagnostic alarms are not enabled by default. Activate the alarms for the relevant module in
the hardware configuration (refer to Chapter Inserting the ET 200S frequency converter into
a SIMOTION project (Page 11)).
If you have parameterized diagnostic alarms, then you should program the alarm processing
sequence according to the principle presented below.
3HULSKHUDO)DXOW7DVN
$ODUPLQIRUPDWLRQ76,GHWDLOV
7ULJJHULQJPRGXOH"
76,ORJ%DVH$GU,Q
76,ORJ%DVH$GU2XW
:KLFKDODUP"
76,LQWHUUXSW,'
$ODUPHYHQW
'LDJQRVWLFDODUP
76,LQWHUUXSW,' B6&B',$*1267,&B,17(55837
$GGLWLRQDOGLDJQRVWLFVGDWDPXVWEHUHDGRXWE\WKHXVHUZLWK
V\VWHPIXQFWLRQBUHDG'LDJQRVWLF'DWD
Figure 6-1 Alarm processing for the frequency converter
Additional references
A detailed description of the system functions can be found in the
SIMOTION System Function/
Variable Devices Parameter Manual. This document is shipped with SIMOTION SCOUT in
electronic form.
Supplement for the ET 200S frequency converter
Function Manual, 01/2015 33