Siemens SIMATIC ET 200S - Page 35

For a more detailed description, refer to the section titled "Diagnostics and monitoring
functions" in the SIMATIC ET 200S FC Frequency Converter Operating Instructions (03/2005
Edition).
Responses to a diagnostic alarm
If a diagnostic alarm is issued, the following occurs:
1. The group error LED (SF) lights up on the ET 200S frequency converter.
2. Diagnostic data is written to the TSI#details variable in the Taskstartinfo of
PeripheralFaultTask. The program assigned to the PeripheralFaultTask is executed.
3. The SIMOTION device goes into STOP mode if a program has not been assigned to the
PeripheralFaultTask.
4. The group error LED (SF) goes out as soon as the error has been remedied.
Bit assignment
The TS#details variable is assigned in the same way as in a SIMATIC system.
Note
For a more detailed description, refer to the section titled "Diagnostics and monitoring
functions" in the SIMATIC ET 200S FC Frequency Converter Operating Instructions (03/2005
Edition).
Alarm processing
6.2 Diagnostic alarms
Supplement for the ET 200S frequency converter
Function Manual, 01/2015 35