Siemens SIMATIC ET 200SP Configuration Manual

3 Configuration
SharedDeviceKonfig
Entry ID: 109741600, V1.0, 11/2016
12
 Siemens AG 2016 All rights reserved
3.2.2 Configuration of project 2
Preparation
Open another instance of the TIA Portal configuration software and create a new
project.
Implementing the devices
Via the project navigation, insert a S7-1500 CPU (here CPU 1511-1 PN). It gets the
name “PLC_2”.
Again, in the “Devices & networks” overview, add a PROFINET interface module
(here IM 155-6 PN ST). In terms of structure and configuration (IP address and
device name), this peripheral station is identical to that in Chapter 3.2.1. Also, you
can copy the already configured ET 200SP from project 1. Thus, you can avoid the
configuration of the peripheral station.
Linking the devices
To set up an automation system, the individual hardware components must be
configured, parameterized and connected to each other. Use the device and
network view to do this.
Proceed as follows:
1. Select CPU 1511-1 PN in the project tree and open its folder.
2. Open the device view of the CPU by double clicking “Device configuration”.
3. In the graphical view, select the CPU interface to be networked. The properties
of the selected interface are displayed in the inspector window.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C