Table of contents
KTP400 Basic, KTP600 Basic, KTP1000 Basic, TP1500 Basic
8 Operating Instructions, 08/2008, A5E01075587-01
4.4 Entering data on the KTP600, KTP1000, TP1500 Basic............................................................ 47
5 Configuring the operating system ............................................................................................................
49
5.1 Opening the Control Panel
..........................................................................................................
49
5.2 Overv
iew ..................................................................................................................................... 50
5.3 Changing MPI/DP se
ttings..........................................................................................................
51
5.4 Changing the network
configuration ...........................................................................................
52
5.5 Changing monitor se
ttings ..........................................................................................................
53
5.6 Displayi
ng information about the HMI device..............................................................................
54
5.7 Calibrating the touch
screen .......................................................................................................
55
5.8 Displaying licens
ing information for the HMI device ...................................................................
56
5.9 Enabling a data channel
..............................................................................................................
57
5.10 Changing pas
sword settings....................................................................................................... 59
5.11 Setting the Screen Sav
er ............................................................................................................
60
5.12 Setting acoustic
signals...............................................................................................................
60
6 Commiss
ioning a project.......................................................................................................................... 61
6.1 Overv
iew .....................................................................................................................................
61
6.2 Operating modes
.........................................................................................................................
62
6.3 Data transmis
sion options...........................................................................................................
63
6.4 Transfer
.......................................................................................................................................
63
6.4.1 Overv
iew ..................................................................................................................................... 63
6.4.2 Starting manual transfer
.............................................................................................................. 63
6.4.3 Starting automatic trans
fer.......................................................................................................... 64
6.4.4 Test
ing a project.......................................................................................................................... 66
6.5 Back
up and restore .....................................................................................................................
68
6.5.1 Overv
iew ..................................................................................................................................... 68
6.5.2 Back
up and restore using WinCC flexible................................................................................... 69
6.5.3 Back
up and restore using ProSave ............................................................................................ 71
6.6 Updating the operating system .............................................................................................
......
73
6.6.1 Overv
iew ..................................................................................................................................... 73
6.6.2 Rese
tting factory settings............................................................................................................ 74
6.6.3 Updating the Operating Sys
tem using WinCC flexible ............................................................... 75
6.6.4 Updating the Operating Sys
tem using ProSave ......................................................................... 76
7 Maintenance
and care .............................................................................................................................
77
7.1 Maintenance and care......................................................................................................
........... 77
7.2 Recy
cling.....................................................................................................................................
78
8 Technical
specifications...........................................................................................................................
79
8.1 Standards, certificates and approvals.....................................................................................
....
79
8.2 Electromagnetic
compatibility ..................................................................................................... 80
8.3 Transp
ort and storage conditions ...............................................................................................
82
8.4 Conditions of us
e ........................................................................................................................
83
To Next Page
Loading...
Need help?
General
