Siemens SIMATIC NET SCALANCE W774-1 RJ-45 - Reset Button

Description
3.3 Reset button
SCALANCE W774-1/W734-1
Operating Instructions, 09/2015, C79000-G8976-C325-06
11
3.3
Reset button
The reset button (position ①) is on the top of the housing:
Functions of the reset button
The reset button has the following functions:
●
Restart of the device
To restart the device, press the Reset button briefly.
Note
If you make changes to the configuration and restart immediately afterwards with the
reset button, the changes may be lost. If you restart the device using the WBM (menu
command "System >
Restart") or using the CLI (command "restart" in the Privileged
EXEC Modus), the configuration changes are always retained.
●
Loading new firmware
If the normal procedure with the "Load & Save" menu of Web Based Management is
unsuccessful, the reset button can be used to load new firmware. This situation can occur
if there is a power outage during the normal firmware update. You will find more detailed
information in the configuration manual SCALANCE W770/W730 WBM.
●
Restoring the default parameters (factory defaults)
You will find more detailed information in the configuration manual SCALANCE
W770/W730 WBM.