"SIMATIC Mobile Reader" app
5.3 Menu overview and functions
Mobile reader SIMATIC RF660M
Operating Instructions, 02/2022, C79000-G8976-C660-01
37
Table 5- 1 The menus of the "SIMATIC Mobile Reader for RFID" app
• Starting/stopping scanning
• Overview of the identified transponders
Display of the acquisition speed
• Starting/stopping scanning
• Selecting the transponder to be edited
• Reading and writing transponder data
• Locking/unlocking memory areas
• 'Killing' transponders
• Starting/stopping scanning
• Overview of the identified transponders
• Selecting the transponder to be located
Transponder localization based on the received signal strength
• Specifying UHF settings
• Exporting and resetting the logbook
• Performing firmware update of the reader head module (Mcon)
• Enabling/disabling acoustic signals/sounds
• Resetting the app to factory settings
• Reading out version information
Click the button of the desired menu to open it.
With the "Menu overview" icon
at the top left, you open a menu overview via which you
an jump directly to the relevant menus or back to the home screen.
Note
Terms within the app and documentation
Note that the term "Tag" is used in the "SIMATIC Mobile Reader for RFID" app, whereas the
term "Transponder" is used in this manual. These
terms are synonyms and have the same
To Next Page
Loading...
