Siemens simatic s7-400 FM 450-1 - Installing and calling parameter assignment screen forms

Parameter assignment
5.2 Installing and calling parameter assignment screen forms
Counter module FM 450-1
42 Manual, 02/2014, A5E03648739-02
5.2
Installing and calling parameter assignment screen forms
Marginal conditions
The following conditions apply to the transfer of parameter assignment data to the CPU:
● STEP 7 must be correctly installed on your programming device.
● The programming device must be correctly connected to the CPU.
● The CPU must be in STOP
Note
During data communication via the MPI you must not pull out or plug in any S7
-400
modules!
Installing the Parameterization Interfaces
To install the configuration package:
1. Place the supplied CD in the CD drive of your programming device or PC.
2. Start the program "Setup.exe".
3. Follow the operating instructions provided by the installation program.
Important information can be found in the readme file.
Result
The components of the configuration package are installed in the following directories:
●
SIEMENS\STEP7\S7LIBS\FMx501LIB:
FCs, UDTs
●
SIEMENS\STEP7\S7FCOUNT:
Configuration software, Readme, Online Help
●
SIEMENS\STEP7\EXAMPLES:
Examples
●
SIEMENS\STEP7\S7MANUAL\S7FCOUNT:
Getting Started, Manuals
Installing parameter assignment screen forms
Call the SETUP.EXE program on the backup copy of your installation diskette. This installs
both the parameter assignment screen forms and the FC CNT_CTRL and the FC DIAG_INF
on your programming device. The FCs are added to the standard library in the "FM_CNT_L"
catalog. Follow the instructions displayed in the SETUP menu on the display.
Example Program
A comprehensive example program is inserted into the "Examples" sub catalog in the STEP
7 catalog in the FM_ZAEHL project during installation.