Siemens simatic s7-400 FM 450-1 - Page 62

Commissioning
7.3 Working steps for parameter assignment
Counter module FM 450-1
62 Manual, 02/2014, A5E03648739-02
Step
Options/procedure
(X)
Assign the FM 450-1
parameters
Specify the behavior of the digital outputs for counter 1
Output 1Q0
Disable
Active from comparison value 1 to overflow
Active from comparison value 1 to underflow
Active for "pulse duration" when comparison value 1 is
reached in up direction
Active for "pulse duration" when comparison value 1 is
reached in down direction
Active for "pulse duration" when comparison value 1 is
reached in up or down direction
Output 1Q1
Disable
Active from comparison value 2 to overflow
Active from comparison value 2 to underflow
Active for "pulse duration" when comparison value 2 is
reached in up direction
Active for "pulse duration" when comparison value 2 is
reached in down direction
Active for "pulse duration" when comparison value 2 is
reached in up or down direction
Pulse duration
0 to 500 ms
Specify the behavior of the digital outputs for counter 2
Output 2Q0
Disable
Active from comparison value 1 to overflow
Active from comparison value 1 to underflow
Active for "pulse duration" when comparison value 1 is
reached in up direction
Active for "pulse duration" when comparison value 1 is
reached in down direction
Active for "pulse duration" when comparison value 1 is
reached in up or down direction
Output 2Q1
Disable
Active from comparison value 2 to overflow
Active from comparison value 2 to underflow
Active for "pulse duration" when comparison value 2 is
reached in up direction
Active for "pulse duration" when comparison value 2 is
reached in down direction
Active for "pulse duration" when comparison value 2 is
reached in up or down direction
Pulse duration
0 to 500 ms