Siemens SIMATIC - 3 Software Description; General Information; Brightness

To Next Page

To Previous Page

PDT IFP Monitor Standard

16 Operating Manual, 10/2017, A5E41104536-AB

Software description

3.1

General information

Note

Full device detection

If you connect or remove an IFP

while the Configuration Center is open, this change is not

immediately detected by the Configuration Center. Only when an IFP has been fully detected

can you make settings for this IFP in the Configuration Center. For full detection or update of

the devic

es in the Configuration Center, select "Menu > Refresh" or restart the Configuration

Center.

3.2

Brightness - SetBrightness

3.2.1

Overview IPC/IFP

Adjusts the display brightness for all connected and detected devices. If the PC used is a

third-party PC, setting the display brightness of the PC is not supported.

3.2.2

Setting the display brightness

Procedure

Note

Deviating numbering

Depending on the graphics chip and operating system, the sequential nu

mbering of the

devices may deviate from the numbering in Windows:

Siemens SIMATIC - 3 Software Description; General Information; Brightness - Setbrightness; Overview IPC;IFP