Panel Drivers and Tools software
1.3 Setup
PDT IFP Monitor Standard
Operating Manual, 10/2017, A5E41104536-AB
9
4. You activate the required software components in the "Configuration" tab, depending on
the device type. Then click "Next".
5. Follow the instructions. The setup installs the associated software.
This process may take several minutes and up to thirty minutes for slow PCs.
6. Restart the PC and log into the user account with administrator rights.
Procedure for PCs that are not preconfigured
If the PDT software does not exist and/or does not start automatically:
1. If the PC does not have an operating system, install an operating system with all the
required components.
If you run the installation from the Restore DVD: Restart the PC once installation is
complete.
Continue with step 3 in the section "Procedure".
2. If a setup of the SIMATIC IPC Wizard or SIMATIC IPC Panel Drivers and Tools V1.1 is
already installed on the PC:
– Uninstall this setup via the Control Panel.
– Restart the computer.
3. If the PC does not have a DVD drive, copy the entire directory of the PDT software
including subdirectories from the "Documentation and Drivers" CD/DVD (included in
scope of delivery of the SIMATIC devices or can be ordered) to a USB memory stick.
4. Place the "Documentation and Drivers" CD/DVD into the DVD drive of the PC.
Alternatively, connect the USB memory stick to the PC.
5. Start the installation with the "Start.exe" file in the directory of the PDT software.
6. Continue with step 3 in the section "Procedure".
To Next Page
Loading...
Need help?
General
