Siemens Simodrive 1PH7 User Manual

Technical Data and Characteristics
2.1 Technical data
1PH7/2-36
 Siemens AG, 2004. All rights reserved
Induction Motors, 1PH7 (APH7S) – 05.04 Edition
Table 2-1 Technical data 1PH7, continued
Order
designation
1PH7
J
[kgm
2
]
U
N
V
I
0
A
Increased
n
max
RPM
I
N
[A]
M
N
[Nm]
n
max
1)
[RPM]
n
N
[RPM]
P
N
[kW]
Shaft height 160 mm
1PH7163-NB 12.0 500 6500 229 30 8000 12.5 339 0.19
1PH7163-ND 22.0 1000 6500 210 55 8000 24.1 315 0.19
1PH7163-NF 30.0 1500 6500 191 72 8000 30.1 319 0.19
1PH7163-NG 36.0 2000 6500 172 85 8000 37.2 333 0.19
1PH7167-NB 16.0 500 6500 306 37 8000 12.7 350 0.23
1PH7167-ND 28.0 1000 6500 267 71 8000 33.1 312 0.23
1PH7167-NF 37.0 1500 6500 236 82 8000 31.9 350 0.23
1PH7167-NG 41.0 2000 6500 196 89 8000 39.7 350 0.23
Shaft height 180 mm
1PH7184-NT 21.5 500 5000 410 76 7000 40 235 0.5
1PH7184-ND 39 1000 5000 372 90 7000 42 335 0.5
1PH7184-NE 40.0 1250 5000 305 85 7000 46.2 380 0.5
1PH7184-NF 51 1500 5000 325 120 7000 64 335 0.5
1PH7184-NL 78 2500 5000 298 171 7000 77 340 0.5
1PH7186-NT 29.6 500 5000 565 106 7000 56 228 0.67
1PH7186-ND 51 1000 5000 487 116 7000 58 340 0.67
1PH7186-NE 60.0 1250 5000 458 117 7000 63 400 0.67
Shaft height 225 mm
2)
1PH7224-NC 55.0 700 4500 750 114 5500 63.5 380 1.48
1PH7224-ND 71.0 1000 4500 678 161 5500 78.5 335 1.48
1PH7224-NF 100.0 1500 4500 636 185 5500 73 385 1.48
____________
1) For continuous operation (with 30% n
max,
60% n
max,
10 % standstill) for a load duty cycle of 10 min.,
max. continuous speed and bearing change intervals, refer to Section 1.4
2) For bearings for increased cantilever force n
max
=4500 RPM

Siemens Simodrive 1PH7 Specifications

General

Brand	Siemens
Model	Simodrive 1PH7
Category	Engine
Language	English