02.98
0-12
Siemens AG 1998 All Rights reserved 6SN1197–0AA00 02.98 Edition
SIMODRIVE 611 (PJ)
!
Important
M600 and M500 are not PE potentials. Hazardous voltages between
300...400V can occur at these terminals with respect to PE. These potentials
may not be connected to PE.
Note
”Safe separation” must be provided between the temperature sensor and the
motor winding of third–party motors.
!
Warning
Start–up/commissioning is absolutely prohibited until it has been ensured that
the machine, in which the components described here are to be installed, fulfills
the regulations/specifications of the Directive 89/392/EEC.
!
Warning
The information and instructions in all of the documentation supplied and any
other instructions must always be observed to eliminate hazardous situations
and damage.
for special versions of the machines and equipment, the information in the
associated catalogs and quotation is valid.
further, all of the relevant national, local and plant/system–specific regula-
tions and specifications must be taken into account.
all work must be undertaken with the system in a no–voltage condition (po-
wered–down)!
!
Warning
Perfect and safe operation of this equipment assumes professional transport,
storage, mounting and installation as well as careful operator control and ser-
vice.
Severe bodily injury or material damage could occur if the warning information
is not observed.
!
Warning
After all voltages have been disconnected, hazardous voltages are present for
at least 4 minutes.
In order to ensure that no hazardous voltages occur, a voltage measurement
should be made. (Generating principle for rotating motors)
Foreword
To Next Page
Loading...
Need help?
General