08.95
0-15
Siemens AG 1997 All Rights reserved 6SN1197–0AA20
SIMODRIVE 611 (PJ)
!
Warning
The information and instructions in all of the documentation supplied and any
other instructions must always be observed to eliminate hazardous situations
and damage.
SFor special versions of the machines and equipment, the information in the
associated catalogs and quotations applies.
SFurther, all of the relevant national, local and plant/system–specific regula-
tions and specifications must be taken into account.
SAll work should be undertaken with the system in a no–voltage condition!
SFor the feed motors, when the rotor is rotating, a voltage is present at the
motor terminals (as a result of the integrated permanent magnets).
SThe motor must be connected according to the circuit diagram supplied.
SIt is not permissible to directly connect the motor to the three–phase supply
and this would destroy the motor.
SSurface temperatures of above 100
d
C can occur at the motor enclosure
surface.No temperature–sensitive parts or components, e.g. cables or elec-
tronic components may be in contact with or connected to the motor.
!
Warning
The holding brake is only designed for a limited number of emergency braking
operations. It is not permissible to use it as working brake.
To Next Page
Loading...
Need help?
General