5.1.4 Preparing the mating faces
● Ensure that the foundation faces are flat and free of contaminations.
Note
Shims
To establish a defined mounting surface, you can order shims (option L31) from our Service
Center.
● Check the dimensions of the mounting-foot holes.
See also
Technical data and drawings (Page 101)
Removing anti-corrosion protection (Page 43)
Lifting the machine (Page 41)
Service and Support (Page 99)
5.2 Lift the machine to where it will be installed, and position it
5.2.1 Checking the load handling attachments
Inspect the load handling attachments such as the load trestles, lifting eyes and ring bolts and
also the lifting gear, before lifting the machine:
● Inspect the load handling attachments on the machine for possible damage. Replace any
load suspension equipment that is found to be damaged.
● Before use, check that the load suspension equipment is correctly attached.
● When lifting the machine, use only approved and undamaged lifting gear of sufficient rated
capacity. Check the lifting gear prior to its use.
WARNING
The machine can be dropped
If the load handling attachments and lifting gear are damaged or not correctly secured,
the machine may be dropped during lifting. This can result in death, serious injury or
material damage.
● Inspect the load handling attachments and lifting gear before use.
Assembly
5.2 Lift the machine to where it will be installed, and position it
SIMOTICS HV C 1NA14544WA600AG0-Z
38 Operating Instructions 06/2018
To Next Page
Loading...
