Figure 5-1 Balancing type on the drive-end side..........................................................................................39
Figure 5-2 Schematic diagram of the water drain holes...............................................................................45
Figure 5-3 Schematic representation of alignment of the machine to the driven machine...........................48
Figure 6-1 Water drip loop............................................................................................................................52
Figure 9-1 Remove the V ring.......................................................................................................................87
Figure 9-2 Install the V ring...........................................................................................................................88
Figure 10-1 Stator and rotor...........................................................................................................................93
Figure 10-2 Roller bearings, NDE...................................................................................................................94
Table of contents
SIMOTICS HV C 1NA14544WA600AG0-Z
Operating Instructions 06/2018 9
To Next Page
Loading...
