Siemens SIMOTICS S-1FK2 - Introduction

Introduction
Information regarding third-party products
Note
Recommendation relating to third-party products
This document contains recommendations relating to third-party products. Siemens accepts the
fundamental suitability of these third-party products.
You can use equivalent products from other manufacturers.
Siemens does not accept any warranty for the properties of third-party products.
What is the target group for these service instructions?
These service instructions address electricians, 󹪝tters and service technicians.
What is shown and how?
Notes
Notes are shown as follows:
Note
A Note is an important item of information about the product, handling of the product or the
relevant section of the document. Notes provide you with help or further suggestions/ideas.
In addition to the notes that you must observe for your own personal safety as well as to avoid
material damage, in this document you will 󹪝nd the following text features:
Instructions
An instruction with a speci󹪝ed sequence starts with the subtitle:
Procedure
The individual handling steps are numbered.
1. Execute the operating instructions in the speci󹪝ed sequence.
A square at the end of the 󹪝nal sentence indicates the end of a speci󹪝c instruction.
❒
Operating instructions without a speci󹪝ed sequence are identi󹪝ed using a bullet point:
• Execute the operating instructions.
Encoder replacement for SIMOTICS S-1FK2 and S-1FT2
Service Manual, 07/2022, A5E52211160B AA 3