Siemens SIMOTICS S-1FK7 - Mounting and Options; Safety Symbols on the Motor

Description of the motors
2.6 Mounting and options
1FK7 G2 synchronous motors
32 Operating Instructions, 05/2021, A5E50907562B AA
2.6 Mounting and options
2.6.1 Safety symbols on the motor
The following warning and information labels are attached to the motor.
• Observe these instructions when handling the motor.
Warning and information labels on the motor
1
Notice: "No impacts and no axial loads on the shaft end"
2
"Warning, hot surface" warning sign
3 WEEE mark
Dispose of the motor in compliance with WEEE directive 2012/19/EU.
China Energy Label (CEL)
The CEL is located on the plastic sheeting wrapped around the motor.
It shows the energy classification of the motor.
Figure 2-3 Example of the "China Energy Label"