Installing
3.1 Plugging the Control Unit onto the Power Module
CU230P-2 Control Units
Compact Operating Instructions, 01/2017, A5E38815802B AA
9
Mounting the operator panel or dummy cover on the IP55 Power Module
Either an operator panel or the dummy cover must be plugged on for the inverter to achieve
degree of protection IP55.
Attaching the operator panel or dummy cover:
Press the operator panel or dummy cover onto the
inverter as shown until you hear it click into place.
Removing the operator panel or dummy cover:
Use a suitable screwdriver to pres
Tools to commission the converter (Page 33)
The following accessory is included in the Power Module scope of supply to connect the
Control Unit with the operator panel:
● An adapter, required for PM230 IP55 Power Modules, FSA … FSC
● A connecting cable and a bar to fix the connector, required for PM230 IP55 Power
Modules, FSD … FSF
Adapter
To Next Page
Loading...
