Siemens SINAMICS G120P - Page 359

Activating the hibernation mode with external setpoint input
With this operating mode, an external source – e.g. a temperature sensor – inputs the main
setpoint.
W
[
 SS෪S
W
\
 UHVWDUWVSHHGS෪S
5HVWDUWVSHHG
6WDUWVSHHG
1RUPDORSHUDWLRQ1RUPDORSHUDWLRQ
$FWXDOYDOXH
6HWSRLQW
6HWSRLQW
+LEHUQDWLRQ
PRGHRIIVHW
5HVWDUWRIIVHW
5HVWDUWVSHHG
%RRVWVSHHGS
6WDUWVSHHG
+LEHUQDWLRQPRGHDFWLYH
0LQLPXPVSHHGS
Speed
Pressure
SSS
SS


S
SW
[
W
\
SS
W
W
Figure 6-66 Hibernation mode using an external setpoint with boost
W
[
 SS෪S
W
\
 UHVWDUWVSHHGS෪S
5HVWDUWVSHHG
6WDUWVSHHG
1RUPDORSHUDWLRQ1RUPDORSHUDWLRQ
$FWXDOYDOXH
6HWSRLQW
6HWSRLQW
+LEHUQDWLRQ
PRGHRIIVHW
5HVWDUWRIIVHW
5HVWDUWVSHHG
6WDUWVSHHG
+LEHUQDWLRQPRGHDFWLYH
0LQLPXPVSHHGS
Speed
Pressure
SSS
SS


S
SW
[
W
\
SS
W
W
Figure 6-67 Hibernation mode using an external setpoint without boost
Advanced commissioning
6.37 Hibernation mode
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 359