Siemens SINAMICS G180 - Safety Information; The Five Safety Rules

List of messages
Display messages
05/2020, 4BS0576F-004
13
Msg-
Number
Display line 1
Display line 2
Text for event memory entry
Fault sup-
pression on
Description
2116 !! Prewarning !! P-Warning1/T =
Cabinet heater
Motor heater,
MotorBearingTemp.,
MotorWindingTemp.,
Insulation Fault,
Fan external,
Cabinet fan,
external,
Set value < 4 mA,
Motor,
Transformer,
I-asymm. motor,
Circuit breaker,
Fuse,
Fusing mains 1,
Fusing mains 2,
Undervoltage,
Overspeed,
Underspeed,
Motor stalled,
set value lost,
Set value limited,
Setp/actv.dev,
Ball valve open,
Ball valve closed,
Control voltage,
Motor overpress.,
Switch high volt.,
Control transf.,
Ind. mains volt.,
Filter cabinet,
Aux. devices,
ResistOutpFilter,
OutputReactor 2,
InputReactor 2,
EarthCurr.,
prog. Text1, prog. Text2,
prog. Text3, prog. Text4,
prog. Text5, prog. Text6,
prog. Text7, prog. Text8,
prog. Text9, prog. Text10
Wrg>CabinetHeater,
Wrg>MotorHeater,
Wrg>M-BearingTemp,
Wrg>M-WindingTemp,
Wrg>InsulationFlt,
Wrg>Blower,
Wrg>CabinetFan,
Wrg>external,
Wrg>SetValue <4mA,
Wrg>Motor,
Wrg>Transformer,
Wrg>I-asymm.motor,
Wrg>Circ. breaker,
Wrg>Fuse,
Wrg>Fusg. mains 1,
Wrg>Fusg. mains 2,
Wrg>Undervoltage,
Wrg>Overspeed,
Wrg>Underspeed,
Wrg>motor stalled,
Wrg>set val.lost,
Wrg>SV limited,
Wrg>Setp/actv.dev,
Wrg>Ball valve op,
Wrg>Ball valve cl,
Wrg>Control volt.,
Wrg>Motor overpr.,
Wrg>Switch high V,
Wrg>Contr transf.,
Wrg>Ind. mains V,
Wrg>Filter cab.,
Wrg>Aux. devices,
Wrg>R-OutptFilter,
Wrg>OutptReactor2,
Wrg>InptReactor2,
Wrg>EarthCurr.,
Wrg>prog. Text1, Wrg>prog. Text2,
Wrg>prog. Text3, Wrg>prog. Text4,
Wrg>prog. Text5, Wrg>prog. Text6,
Wrg>prog. Text7, Wrg>prog. Text8,
Wrg>prog. Text9, Wrg>prog. Text10
- This is a user-defined warning. It is parameterized as per
"P-WARNINGS/P-Warning1/T = Text selection values". The text of the
warning can either be selected from a number of standard texts (see left-
hand column) or can be a programmed text. Normally it is not a warning
concerning the inverter, it is rather concerning the installation into which
the inverter is integrated.
2117 !! Prewarning !! P-Warning 2/T= as no. 2116 as no. 2116 - P-Warning 2: as no. 2116