Siemens SINAMICS SH150 - Opening Doors in Preparation for Use; Figure 4-6 Example: Label with Instructions for Opening the Doors

4.4.4 Opening doors in preparation for use
NOTICE
Damage to the locking mechanism caused by incorrectly opening the doors
You can damage the locking mechanism if you open the doors incorrectly.
● When opening the doors, follow the steps described.
● If the locking mechanism is damaged it is essential that you have it repaired before
commissioning the drive system. If this is the case, then contact the Service Center. You
can find the relevant contact persons at "Service & Support".
The drive is delivered in a closed state. A label showing how to open the doors in a current-free
state is located on the door.
Figure 4-6 Example: Label with instructions for opening the doors
Proceed as follows:
1. There is a screw in the door. Under the screw you will find the opening for manually opening
the doors. Remove the screw.
2. Insert a screwdriver into this opening.
3. Turn the door handle until you feel resistance.
4. Remove the screwdriver from the opening.
5. Open the doors.
After opening the doors, remove the label with the instructions for safety reasons. The label
is only required for opening the doors the first time.
Preparations for use
4.4 Unpacking the cabinets
SINAMICS SH150 6SL3805
52 Operating Instructions 05/2020